HomeMy WebLinkAboutM7221137.0020.1.060623POST-INSTALLED ANCHORS REPORT
Report Number: M7221137.0020 Service Date: 06/06/23 20225 Cedar Valley Rd Ste 110
Report Date: 06/06/23 Lynnwood, WA 98036-6365
425-742-9360
Client Project
City of Renton WA City of Renton Gene Coulon Memorial Beach Park (T)
Attn: Alan J. Wyatt 1201 Lake Washington Blvd N
1055 S Grady Way Renton, WA
Renton, WA 98057-3232
Project Number: M7221137
Services: Special Inspections / Materials Testing
Mayes/Terracon Rep.: Craig Williams
Reported To: Aaron, American Construction
Contractor: American Construction
Report Distribution:
(1) City of Renton WA, Alan J. Wyatt (1) American Construction Co Inc, Aaron McMahill
(1) American Construction Co Inc, John Blair (1) Mayes Testing Engineers, Inc, Jim Kay Reviewed By: ____________________________________
(1) WSP USA Inc, Garth Nelson, P.E. Barry Tuttle
Project Field Manager
The tests were performed in general accordance with applicable ASTM, AASHTO, or DOT test methods. This report is exclusively for the use of the client indicated above and shall not be reproduced except in full without the written consent of our company. Test results transmitted herein are only applicable to the actual samples tested at the location(s) referenced and are not necessarily indicative of the properties of other apparently similar or identical materials.
DM018, 04-29-22, Rev. 5 Page 1 of 1
General Information
Aaron, American Construction requested Terracon be on site for adhesive anchor observation of the adhesive anchors being installed by American Construction. Results of observation(s) performed today were reported to Aaron, American Construction. The construction documents referenced for this observation include: Approved plans and documents. Permit No: C21005257.
Anchor System Information
The following adhesive types were used during today’s observation:
Adhesive No. ICC Report Adhesive Lot No. Exp. Date Time Until Full Cure Referenced
1 3814 Hilt Hit-RE 500 V3 15177710 1/31/24 4 hr(s) 1/C-9 on S-13 & Email from Garth Nelson E.O.R.
Anchor Installation
Anchor installation was observed utilizing the adhesive(s), noted above, as follows: (2) Water line Support Anchors
Adhesive No. Time Installed Locations Quantity Anchor Size & Type
Length &
Embedment
(in.)
Spacing &
Edge Distance
(in.)
Status*
1 1000 North and South bridge abutments 8 3/4" All-Thread 6.5" & 5" Per plan & 16" Complies
* See below for more information Holes were cleaned prior to installation by: compressed air, brush. Ambient Temperature during observation was 74° F.
Compliance
Based on our observations and testing, the post-installed anchors referenced above appear to be in general accordance with the project
documents.