HomeMy WebLinkAbout116.2 (7/27/2022) LUMINAIRE COMPONENTS
MINIM
HEADI MODULE: ROUND SHAPE. A HEAVY SPUN ALUMINUM HOOD, WITH AN
ALUMINUM DECORATIVE CUPOLA AND CAST ALUMINUM FINIAL, TOPS AN
NJECTION MOLDED CLEAR ACRYLIC RIBBED (VS3AR) VESSEL. UV
POLYMER RESISTANT. THE VESSEL IS MECHANICALLY ASSEMBLED WITH AN
ALUMINUM DIE-CAST RING ON THE LOCKING SYSTEM.
OPENING SYSTEM: A QUARTER-TURN LOCKING MECHANISM WITH CONSISTENT
PRESSURE POINTS. ALLOWS A TOOL-FREE ACCESS INSIDE THE LUMINAIRE,
TO THE LEDS AND DRIVER. MADE WITH CAST ALUMINUM PARTS AND
1 ,71\-617)
SEALED WITH A GASKET COMPRESSION SYSTEM. THE LUMINIARE OFFERS
I•> AN IP66 WEATHERPROOF PROTECTION.
CONE MODULE: A SPUN ALUMINUM BALLAST HOUSING WITH STAINLESS STEEL
CAPTIVE RETAINING LATCHES. CERTIFICATION, MAINTENANCE AND
LUMINAIRE CODIFICATION STICKERS ARE LOCATED ON THE CONE.
FITTER MODULE: CAST ALUMINUM ALLOY 356 FITTER COMPLETE WITH FOUR (4)
ARMS AND ONE DECORATIVE RING, SECURED ON POLE WITH 3 SET
SCREDS 5/16-18 UNC. SLIP-FITS ON A 4" OD BY 3" LONG TENON.
A
HEAD
MODULE
ak
OPTICAL/ELECTRICAL COMPONENTS
11. LED BOARD: WATTAGE PER PLANS. 4000K (WHITE), SUPER HIGH FLUX
OUTPUT AND HIGH LUMINANCE, DESIGN FOR HIGH CURRENT OPERATION.
FAST TOOL-FREE MAINTENANCE THAT ALLOWS INDIVIDUAL REPLACEMENT
OF A DEFECTIVE LED BY PULLING OUT THE PROPER UNIT.
OPTIC: IES TYPE II (2L), III (3L), V(5L). THE OPTIC'S REFLECTOR IS MADE OF
PRE-ANODIZED ALUMINUM REFLECTING SHEETS(86%MIN. REFLECTION),
SEGMENTED IN MULTIPLE FACETS AND VENTILATED BY MULTIPLE
OPTIC PERFORATION AND BY HEAT SINK RADIATOR TO KEEP THE LAMPS
MODULE TEMPERATURE DOWN AND INCREASE THEIR LONGEVITY. THE ORIENTATION
OF EACH FACET HAS BEEN METICULOUSLY CALCULATED TO OPTIMIZE THE
• LIGHT DISTRIBUTION FOR EACH APPLICATION.
TWIST-LOCK j DRIVER MODULE: WITH DRIVER, PRIMARY VOLTAGE 120 TO 277 VOLTS. 60
OPENING SYSTEM HZ. ASSEMBLED ON A TOOL-FREE REMOVABLE STAINLESS STEEL TRAY
WITH QUICK-DISCONNECT CONNECTORS. HIGH POWER FACTOR OF 90%.
MINIMUM STARTING TEMPERATURE -40'F.
Illil
DRIVER
MODULE GENERALIOPTIONS
!0❑1
WIRING/HARDWARE: TYPE TEW 14-7, 12" MINIMUM EXCEEDING FROM
LUMINAIRE. ALL ELECTRICAL CONNECTIONS BETWEEN MODULES ARE MADE
WITH QUICK-DISCONNECT CONNECTORS. ALL EXPOSED HARDWARE IS
STAINLESS STEEL. EPDM AND/OR SILICON GASKETING ARE APPLIED.
COLOR: RAL9005TX(JET BLACK)
42_10 FINISH: TEXTURED.
APPLICATION OF A POLYESTER POWDER COAT OF PAINT. (5 MILS/127
MICRONS). THE FINISH MEETS THE ASTM G7, B117 AND 01654
REQUIREMENTS RELATIVE TO SALT SPRAY AND HUDMIDITY RESISTANCE.
FITTER
MODULE
G T 0, NEIGHBORHOOD STREET STD. PLAN - 116.2
PUBLIC WORKS
+(�,R+; DEPARTMENT PEDESTRIAN LUMINAIRE FIXTURE AP9�ROVED:
• • DETAILS _ ,/__
/y DA I