HomeMy WebLinkAboutAP_OPTIFLUX-WATERFLUX-UFM 3030__en_MID MI 001 ModuleD___ MI EC quality system
Approval
Certificate: CE-101 (replaces certificate of 19 November 2010)
NMi Certin B.V.,
designated and notified by the Netherlands to perform tasks with respect to conformity
modules mentioned in article 9 of Directive 2O04/22/EC, declares that the quality system of
Krohne Altometer
Kerkeplaat 12
3313 LC Dordrecht
meets the applicable requirements of annex D of Directive 20O4/22/EC for the conformity
assessment of instrument category:
Water Meters and Heat Meters
Scope of the certificate is described in the annex of CE-101.
The certificate is initially granted on 20 November 2009.
This certificate remains valid until 20 November 2012,
under the condition that the quality system is maintained satisfactory.
NMi Ce 'n B.V., Notified Body number 0122 +
10 FkuO11 M,CE-101
Board
NMi Certin B.V. This document is issued under the provision that Parties concerned can lodge objection
Hugo de Grootplein 1 no liability is accepted and that the applicant against this decision,within six weeks after
3314 EG Dordrecht shall indemnify third-party liability. the date of submission,to the general 7_ w`
The Netherlands manager of NMi(see www.nmi.nl). \\��I
T+31 78 6332332 The designation of NMi Certin B.V.as Notified
certin@nmi.nl Body can be verified at http://ec.europa.eu/ Reproduction of the complete document MGMT. SYS.
www.nmi.nl enterprise/newapproach/nando/ only is permitted. RvA C 061
M
' Page 1 of 1
Annex to certificate number: CE-101
Valid from: 11 July 2011 until 20 November 2012
Replaces annex dated 10 February 2011
List of EC type approval certificates: �-
Approval Watermeters Type Manufacturer #4 OWWft
q�
T10003 Optiflux Krohne Altometer
T10201 Waterflux Krohne Altometer \ -r
T10350 Waterflux 3300 Krohne Altometer
Approval Heat meters Type Manufacturer
0402-MID-50 30 01 Flow sensor Krohne Altometer
UFM3030
Related persons:
Management representative A.H. de Boer
Quality Assurance manager J.C. van der Graaf
Verification officers The process of the verification is made by a
verification program.
The verification officers are approved by the
internal qualification program.
List of documentation, as part of this certificate of approval:
• The applicants document for EC Declaration of Type Conformity;
• The calibration certificates with regard to traceability of the standards
and measuring equipment;
• The quality manual, procedures and working instructions as far as
relevant for the metrological aspects of water meters with
CE-marking.