HomeMy WebLinkAboutAP_OPTIFLUX-WATERFLUX__en_MID Module D_121120__ M � EC quality system
Approval
Certificate: CE-101 (replaces certificate of 20 November 2009)
NMi Certin B.V.,
designated and notified by the Netherlands to perform tasks with respect to conformity
modules mentioned in article 9 of Directive 2OO4/22/EC, declares that the quality system of
Krohne Altometer
Kerkeplaat 12
Dordrecht
meets the applicable requirements of annex D of Directive 2OO4/22/EC for the conformity
assessment of instrument category:
Watermeters
Scope of the certificate is described in the annex of CE-101.
The certificate is initially granted on 20 November 2009.
This certificate remains valid until 20 November 2012,
under the condition that the quality system is maintained satisfactory.
NMi C n B.V., Notified Body number 0122 OMI
19 No;ee 2010
RECOGNISED
CE-101
an
Headication Board
NMi Certin B.V. This document is issued under the provision that Parties concerned can lodge objection /1
Hugo de Grootplein 1 no liability is accepted and that the applicant against this decision,within six weeks after /�e'
3314 EG Dordrecht shall indemnify third-party liability. the date of submission,to the general 7_ �w`
The Netherlands manager of NMi(see www.nmi.nl). \`J
T+31 78 6332332 The designation of NMi Certin B.V.as Notified MGMT. SYS.
certin@nmi.nl Body can be verified at http://ec.europa.eu/ Reproduction of the complete document www.nmi.nl enterprise/newapproach/nando/ only is permitted. pp i1VA C 001
M ' Page 1 of 1
Annex to certificate number: CE-101
Valid from: 20 September 2010 until 20 November 2012
Replaces annex dated 20 November 2009
List of EC type approval certificates:
Approval Type Manufacturer +
T10003 Optiflux Krohne Altometer
T10201 Waterflux Krohne Altometer
Related persons:
Management representative A.H. De Boer
Quality Assurance manager J.C. van der Graaf
Verification officers The process of the verification is made by a
verification program.
The verification officers are approved by the
internal qualification program.
List of documentation, as part of this certificate of approval:
• The applicants document for EC Declaration of Type Conformity;
• The calibration certificates with regard to traceability of the standards and
measuring equipment;
• The quality manual, procedures and working instructions as far as relevant for
the metrological aspects of water meters with CE-marking.