HomeMy WebLinkAboutT-2692B8ENO OF
I IS
0
UT
NP
e
a
APPLY APPROVED RETARDANT FOR W ETCH
TO 510E FORMS OR K" F'OUGHENCP SURFACE
TREATMENT 6Y APPROVED MECHANICAL MEANS.
SEE "PLAN -'NEB FTCHLVG AND FLANGE CLIP DETAIL"
ON SHEET 00.00 36.
%, X5`X
COMiT AT
OF EX
`1 3' CIA, HOLE FOR END DIAPHRAGM REINF. SEE
j "WFIOOPYG SPLICED GIRDER DETAILS 3 OF S"
SHEET GO-O 3 FOR LOCATIONS
I
k ORG HER 1 OR 4
f..p.
P BPL(CE (YYP)
LAP
5PIICE (TYP.)
05
SEE bUCT
SPLICE DETAIL"
G8 AN
2' -0' CLOSURE
—SEE GENERAL NOTE, SHEET
FOR COLN STRENGTH:
DETAIL A
Q INTER.MEOIATE DIAPHRAGM /TYP.) FOR LOCATIONS. SEE "SPAN 1 & 2 FRAMING PLAN'
AND "SPAN 3 FRAMING PLAN 6 TYPICAL SECTION' SHEFTS BP -0-30 AND 06-0-51
I
ON THE INTERIOR
EXTERIOR GIROERkk
ADJUST HOLE LOCATION VERTICAIY
TO M155 POSTdEN51014ING GUCTSkx
PRECAST LONGITUDINAL SECTION
kMEA5URED ALONG GIRDER GRACE OCR GIRDER SCHEDULE ON
"WFIOOPTG SPLICED GIRDER - DETAILS 5 OF Y SHEET 50-0-3E
7UCT SPLICE DETAIL
NOTE:
k THE CONTRACTOR SHALL MEASURE THE HORIZONTAL
AND VERTICAL DEVIATIONS OF THE DUCTS FROM PLAN
LOCATIONS AT THE SPLICE LOCATIONS IN FIELD,
THE MEASURED DEVIATIONS 5HALLBE SIISMITTED TO
THE ENGINEER MR APPROVAL PRIOR TO THE PLRCEMFNT
OF ANY SPLICE KFINFORCEMENT,
ENTERED 8Y CHECKED BY DEMON
ROMPER:
.I. BMNWN
DESIGN
TASK LEWD:
P. DVEf1YNER
ENO OF
NOTE:
''\OMIT HOLES AND PLACE IN5ERTS ON THE LIPmIOR FACE
OF THE EXTERIOR GIROFKG PLACE HOLES AND INSERTS
PARALLEL TO SEEN. INSERTS SHALL SO 1"O 5UR4E
Hi TENSILE, IANCAS'.'ER MALLEABLE, OAYTO.N- SUPERIOR
F -62 FLARED THIN SLAB /1" X 4W) FERRULE INSERT
OR APPROVED EQUAL.(TYFICAL)
- kkFfNAL ASdONSTRL'CTED CLOSURE POOR GAPS 5ETWEEN
GIRDER EN05 VARIED FROM 2' -2" TO 2' -3".
i GIRDER 6 4 DUCTS
STRAND PATTERN AT � SPAN
STRAIGHT STRAW LOCATION 5EGUEA'CE
SHALL 5E AS SHOWN (1).(2) ETC.
C.6. OF
CL05URE POUR
I
I
+ -m xxx
If DUCTS
I
TENDON IN DAD CURVE
STRAND LOCATION DETAIL
NOTE;
xx TENDON ECCENTRICITY FROM DUCT
CENTERLINE IS APPROXIMATED.
CONTRACTOR TO CONFIRM 5A5E0 ON
DUCT SIZE
im
_. TO S
1 169 I
STAGE 2 -WIDENING
♦ r AND SIR 515 INTERCHANGE
i Y