The URL can be used to link to this page

Home My WebLink About12-066 (R-8 NE 7th Street Short Plat) DEPARTMENT OF COMMUNITY AND ECONOMIC DEVELOPMENT M E M O R A N D U M DATE: August 30, 2012 TO: Pre-Application File No. 12-066 FROM: Vanessa Dolbee, Senior Planner SUBJECT: NE 7th Street Short Plat General: We have completed a preliminary review of the pre-application for the above-referenced development proposal. The following comments on development and permitting issues are based on the pre-application submittals made to the City of Renton by the applicant and the codes in effect on the date of review. The applicant is cautioned that information contained in this summary may be subject to modification and/or concurrence by official decision-makers (e.g., Hearing Examiner, Community & Economic Development Administrator, Public Works Administrator, Planning Director, Development Services Director, and City Council). Review comments may also need to be revised based on site planning and other design changes required by City staff or made by the applicant. The applicant is encouraged to review all applicable sections of the Renton Municipal Code. The Development Regulations are available for purchase for $50.00 plus tax, from the Finance Division on the first floor of City Hall or online at www.rentonwa.gov Project Proposal: The subject property is located on the south side of NE 7th St at 2517 and 3603 NE 7th St. The proposal is to subdivide the two existing parcels into 7 lots for the future construction of single family residences. The subject property totals 57,389 square feet in area, and is zoned Residential-8 dwelling units per net acre (R-8). Access to the site would be gained via a proposed access easement extended from NE 7th St. for proposed lots 3 – 7 and direct access off of NE 7th street would be provided for proposed lots 1 and 2. There appear to be no critical areas on site. Current Use: The site currently contains two single family residences proposed for demolition. Zoning/Density Requirements: The subject property is located within the R-8 zoning designation. The density range allowed in the R-8 zone is a minimum of 4.0 to a maximum of 8.0 dwelling units per acre (du/ac). The area located within the proposed access easement would be deducted from the gross site area to determine the “net” site area prior to calculating density. After the deduction of the area within proposed access easements (approximately 5,960 square feet) from the 57,389 gross square foot site area (57,389 gross square feet – 5,960 total deducted area = 51,429 net square feet = 1.18 net acres), the proposal would arrive at a net density of 5.93 dwelling units per acre (7 units / 1.18 acre = 5.93 du/ac which is within the density range of the zoning classification. The applicant would be required to comply with the density requirements of the zone. Development Standards: The project would be subject to RMC 4-2-110A, “Development Standards for Single Family Zoning Designations” effective at the time of complete application (noted as “R-8 standards” herein). Minimum Lot Size, Width and Depth – The minimum lot size permitted in the R-8 is 4,500 square feet for parcels greater than 1 acre in size and 5,000 square feet for lots 1 acre or less in size. The total lot area of the subject site is more than 1 acre; therefore a minimum lot size of 4,500 square feet is applicable to the proposed project. A minimum lot width of 50 feet for interior lots and 60 feet for corner lots, as well as a minimum lot depth of 65 feet, is also required. The proposal appears to comply with the lot size, width and depth standards of the zone. Detailed information regarding lots size would be required at Short Plat submittal to show compliance with lot width, depth and size requirements. Building Standards – R-8 zone allows a maximum building coverage of 35% of the lot area or 2,500 square feet, whichever is greater for lots over 5,000 square feet in size. Building height is restricted to 30 feet from existing grade. Detached accessory structures must remain below a height of 15 feet. The gross floor area must be less than that of the primary structure. Accessory structures are also included in building lot coverage calculations. The proposal’s compliance with the building standards would be verified at the time of building permit review for the new residences to be located on all lots. Setbacks – Setbacks are the minimum required distance between the building footprint and the property line and any private access easement. The required setbacks in the R-8 zone are 15 feet in front for the primary structure, 20 feet in the rear, 5 feet on interior side yards, and 15 feet on side yards along streets (including access easements) for the primary structure. The setbacks for the new residence would be reviewed at the time of building permit. Lot Configuration – One of the following is required: Lot width variation of 10 feet (10') minimum of one per four (4) abutting street-fronting lots, or Minimum of four (4) lot sizes (minimum of four hundred (400) gross square feet size difference), or A front yard setback variation of at least five feet (5') minimum for at least every four (4) abutting street fronting lots. Building Design Standards – The proposed structure would be subject to the Residential Design Standards outlined in RMC 4-2-115. The proposal’s compliance with the residential design standards would be verified at the time of building permit review. Access/Parking: Access to the proposed lots would be provided via an access easement extended from NE 7th St. for lots 3 – 7 and direct access off of NE 7th Street is proposed for lots 1 and 2. Each lot is required to accommodate off street parking for a minimum of two vehicles. Driveways: The maximum driveway slopes cannot exceed 15%, provided that driveways exceeding 8% are to provide slotted drains at the lower end of the driveway. If the grade exceeds 15%, a variance is required. The maximum width of single loaded garage driveways shall not exceed nine feet (9') and double loaded garage driveways shall not exceed sixteen feet (16'). Landscaping – Except for critical areas, all portions of the development area not covered by structures, required parking, access, circulation or service areas, must be landscaped with native, drought-resistant vegetative cover. The development standards require that all pervious areas within the property boundaries be landscaped. The minimum on-site landscape width required along street frontages is 10 feet. Please refer to landscape regulations (RMC 4-4-070) for further general and specific landscape requirements (enclosed). A conceptual landscape plan shall be submitted at the time of Short Plat application. Significant Tree Retention: If significant trees (greater than 6-inch caliper) are proposed to be removed a tree inventory and a tree retention plan along with a tree retention worksheet shall be provided with the formal land use application. The tree retention plan must show preservation of at least 30 percent of significant trees, and indicate how proposed building footprints would be sited to accommodate preservation of significant trees that would be retained. If the trees cannot be retained, they may be replaced with minimum 2 inch caliper trees at a ratio of six to one. Critical Areas: There appear to be no critical areas on site. Environmental Review Subdivision of land into nine or fewer lots or tracts is exempt from Washington State Environmental Policy Act (SEPA) review, unless critical areas are known to be on or near the site. The proposal would be exempt from Environmental Review per WAC 197-11-800. Permit Requirements: The proposed subdivision would require Administrative Short Plat Approval. All land use permits would be processed within an estimated time frame of 6-8 weeks. The Short Plat Review application fee is $1,400. A 3% technology fee would also be assessed at the time of land use application. Detailed information regarding the land use application submittal is provided in the attached handouts. Fees: In addition to the applicable building and construction fees, the following mitigation fees would be required prior to the recording of the plat. Impact fees, which would replace mitigation fees, may be adopted prior to construction. Those fees are to be determined. The following are current fees: A Fire Mitigation fee of $488.00 per new single family residence. A Transportation Mitigation Fee based on $75.00 per each new average daily trip attributable to the project; and A Parks Mitigation Fee based on $530.76 per new single family residence. A School District Impact Fee based on $6,392 per new single family residence. A handout listing all of the City’s Development related fees in attached for your review. Expiration: The preliminary short plat approval is valid for two years with a possible one-year extension.