HomeMy WebLinkAbout402.2?C
TCC nC A''PROPRIATE SIZE
SEE N OTE 6
NOTES:
"RELINER" BRAND STAINLESS
STEEL ADJUSTABLE CLAMPING
BRACKETS OR APPROVED EQUAL
90° BEND
3/4 THE DIAMETER OF
THE DOWNSTREAM PIPE
1. SANITARY SEWER MANHOLE DROPS ARE ONLY TO BE USED UPON
APPROVAL BY THE WASTEWATER UTILITY SECTION.
2. ALL PIPES AND FITTINGS SHALL BE SIMILAR SIZE AND MATERIAL
AS INCOMING MAINLINE.
3. MINIMUM SIZE MANHOLE FOR INSIDE DROP CONNECTION SHALL BE
60" DIAMETER.
4. CONNECTIONS TO MANHOLE SHALL BE MADE USING GPK ADAPTOR,
KOR-N-SEAL BOOTS OR APPROVED EQUAL.
5. WITHIN A 60" DIAMETER MANHOLE, THE MAXIMUM ALLOWABLE DIAMETER
OF THE INSIDE DROP PIPING IS 12". INSIDE DROPS EXCEEDING 12" IN
DIAMETER OR MULTIPLE DROPS SHALL BE REVIEWED BY THE WASTEWATER
UTILITY AND MAY REQUIRE A LARGER DIAMETER MANHOLE.
6. "RELINER" BRAND STAINLESS STEEL ADJUSTABLE CLAMPING BRACKETS
OR APPROVED EQUAL SHALL BE INSTALLED WITHIN 6" OF
BOTH BELL AND SPIGOT ENDS OF EACH DROP PIPE.
IF DROP PIPE LENGTH EXCEEDS 5 FEET THEN CENTER STRAPS
SHALL BE INSTALLED WITH A MAXIMUM SPACING OF 4 FEET
ON CENTER. BRACKETS SHALL BE ATTACHED UTILIZING STAINLESS
STEEL EXPANSION BOLTS, MIN. 2 EACH AT CONNECTION POINTS.
Y o STD. PLAN — 402.2
PUBLIC WORKS INSIDE DROP CONNECTION PROVED:
DEPARTMENT FOR SANITARY MANHOLE
pyo, WDA