HomeMy WebLinkAbout106 PATCHED AREA
'�-
i �
� �
� �
A � � q
� COVER �
� �
/
COVER PER STD PLAN 401 \ � /
+
(SEE NOTE 9)
SEAL WITH AR 4000 OR APPROVED
�
EQUAL AND DRY SAND AFTER P L A N
PATCHING NTS
OUTSIDE DIAMETER OF
(SEE NOTE 9) ADJUSTMENT RING AND x SEE NOTE 2
X gOTTOM OF FRAME
..t----
� �
�
MORTAR JOINT(S) (3/8" MIN.-2" MAX.) ADJUSTMENT RING (1" MIN.). SEE
SEE NOTE 3 AND SPECIAL PROVISION NOTE 6.
7-05.3(1).
SECTION A-A
NOTES
1. REMOVE PAVEMENT AND BASE MATERIALS FOR A DISTANCE 5. CONSTRUCTION AND ADJUSTMENT SHALL BE PERFORMED
WHICH IS EQUAL TO THE DIAMETER OF THE FRAME PLUS ONE ONLY BY A JOURNEYMAN MASON.
FOOT(MIN.). ADJUST CASTING FRAME TO PAVEMENT
SURFACE USING RISER RINGS AND MORTAR. 6. ADJUSTMENT OF THE FRAME TO GRADE SHALL BE
ACCOMPLISHED WITH ADJUSTMENT RINGS AND MORTAR ONLY.
2. REPLACE EXCAVATED MATERIAL WITH A MINIMUM OF 8"OF THE USE OF SHIMS IS PROHIBITED.
HMA CLASS�"PG 64-22(OR TO A DEPTH THAT�S 2"BELOW
THE BOTTOM OF THE UPPER ADJUSTMENT RING WHICHEVER 7• FRAME SHALL BE ADJUSTED TO PAVEMENT GRADE BY
IS GREATER)OR AS APPROVED BY THE ENGINEER. TAPPING UNTIL FRAME IS FLUSH WITH PAVEMENT AS
DETERMINED WITH A STRAIGHT EDGE OF SUFFICIENT LENGTH.
3. ADJUSTMENT RINGS AND FRAME SHALL BE FULLY BEDDED IN
MORTAR.MORTAR SHALL BE ASTM C270 FOR TYPE S. 8. ALL MORTAR JOINTS SHALL BE TRIMMED FLUSH AND REMAIN
VISIBLE UPON COMPLETION.
4. MORTAR SHALL BE MIXED AND APPLIED PER
MANUFACTURERS DIRECTIONS. 9. X=1'-0"MIN.TO 2'-6"MAX.-PER ENGINEER'S INSTRUCTION
STD. PLAN - 106
_•j� PUBLIC WORKS TY�'�CAL CONSTRUCTION A ROVED:
'al'� DEPARTMENT AND ADJUSTMENT OF ;fl
MANNOLE RISER3
e�o� �r>tor DA E