HomeMy WebLinkAboutRS_Geology_Soils_Report_R2B_SSDP_171128_v1ATTACHMENT 9 - GEOLOGY AND
SOILS REPORT
I-405, SR 169 to I-90, Renton to Bellevue Project Environmental Assessment | March 2006
Geology and Soils
5.13-1
Geology and Soils
Geology is the study of the origin, history, materials, and
structure of the earth, along with the forces and processes
operating to produce changes within and on the earth.
What is the geology of the project area?
Most of the I-405 Renton to Bellevue project area is located
along the west-facing slopes of the topographic trough
occupied by Lake Washington. The alignment also crosses or
runs adjacent to several drainages, most notably the Cedar
River, May Creek, and Coal Creek. These drainages are
typically occupied by relatively loose or soft soils. Several
ancient landslides and areas of landslide-prone soils are
located along the project alignment, especially between May
Creek and Coal Creek.
Landslide Conditions
Geologists identified a number of landslide conditions along
I-405 in the project area. In the Kennydale area, we identified
several small, relatively shallow landslides, along with one
larger, and presumably deeper, one along the north side of NE
Park Drive. Shallower debris slide and debris flow-type
failures are possible where cuts are planned that intersect
swales along west-facing slopes. It is relatively easy to control
this type of landslide.
I-405, SR 169 to I-90, Renton to Bellevue Project Environmental Assessment | March 2006
Geology and Soils
5.13-2
Exhibit 5.13-1: Landslide areas
Coal Cre
e
k
P
a
r
k
w
a
y
N 30th St
L
a
k
e
W
a
s
h
i
n
g
t
o
n
B
l
v
d
S
E
N E 3 r d S t
N 8th St
N E Park D
r
L
a
k
e
W
a
s
h
i
n
g
t
o
n
RENTON
NEWCASTLE
BELLEVUE
S u n s e t B
l v d N
M
e
r
c
e
r
S
l
o
u
g
h
C
o
a
l
C
r
e
e
k
L
a
k
e
h
u
r
s
t
C
r
e
e
k
M a y C r e e k
Cedar River
NE 44th St
112th Ave SE
BEAUX
ARTS
King
County
S E A T T L E F A U L T Z O N E
±
0 0.5 1
Miles
Landslide Hazard
Arterial
Freeway
Streams
Lake
Municipality
Approximate
Southern
Limit
Approximate
Northern
Limit
What soils are found in the project area?
Generally, the project area is underlain by dense glacial soils.
Notable exceptions include the alluvium (deposits from the
streams and rivers) in the stream drainages that cross the
project alignment, localized areas of artificial fill, lake and peat
deposits, and recessional outwash (deposits of sand and
gravel from glacial meltwater).
Many of the upland slopes in the study area are sites of
prehistoric landslide activity (see Exhibit 5.13-1). The
landslides likely occurred during and after the retreat of
glacial ice at the end of the last glaciation. Many of the ancient
landslide deposits have been relatively stable; however, they
can become reactivated when disturbed by development.
Geologists also identified numerous shallow landslides and
three large deep-seated landslide complexes in the Coal Creek
area. The largest of these landslide complexes is located north
of May Creek and appears to extend to Lake Washington on
its northern end. No landslide slopes were identified near
SR 169.
Liquefaction Hazard Areas
Liquefaction occurs during a strong earthquake when ground
movements cause loose, saturated granular soils to lose their
strength and essentially become a heavy liquid. Liquefaction
can result in ground settlement, lateral spreading or
movement of ground, and foundation failure. In the Renton
portion of the project area west of I-405, the potential for
liquefaction is high. Likewise, the potential for liquefaction in
the May Creek area is high and moderate in the Coal Creek
area. Geologists do not consider liquefaction of soils to be an
issue in the Kennydale area.
Soft Ground Areas
Areas underlain by soft, compressible organic and clay soils
can present settlement and subgrade stability problems for
road construction. Embankments placed on these types of
conditions can cause substantial settlement or induce an
embankment foundation failure. In addition, structures or
walls located in areas underlain by soft ground conditions are
likely to experience much stronger shaking in an earthquake
than adjacent areas. With the exception of the area to the west
of I-405, soft soils are generally not likely to be encountered in
the Renton portion of the project area. Geologists have
I-405, SR 169 to I-90, Renton to Bellevue Project Environmental Assessment | March 2006
Geology and Soils
5.13-3
identified soft ground areas in the vicinity of both Coal Creek
and May Creek where measures will need to be taken to
account for potential settlement and stability. Geologists do
not consider soft ground areas to be an issue in the
Kennydale area.
How will the project affect geologic features?
Soils and erosion
Construction will involve substantial earthwork, including
major cuts (excavations) and fills. Cut materials will be reused
in areas of the project that require fill. However, there will
likely be areas where the excavated soils are unsuitable for
reuse, particularly during wet weather. Unsuitable soils will
be exported offsite for disposal. Similarly, we expect to import
some fill soils for use along the alignment. New fill materials
(over 50 cubic yards) used in the Renton Aquifer Protection
Area must be certified by WSDOT as contaminant free.
Seismicity is a factor within the study area because the Seattle
Fault Zone crosses the project alignment (see Exhibit 5.13-1). If
a fault exhibits surface displacement during future project
operation, considerable damage to the roadway, utilities, and
structures can result. The current WSDOT bridge design
philosophy for seismic events is to preserve life-safety through
the prevention of collapse. Major changes in bridge geometry
and even non-serviceability following the design level seismic
event are potential results; however, the bridge must not
collapse.
Erosion will be a concern during construction. Implementing
a temporary erosion and sedimentation control (TESC) plan,
as described later, will substantially reduce the volume of
erosion and the potential for discharge of silt-laden runoff to
nearby bodies of water.
What measures are proposed to avoid or minimize
effects to geology and soils during construction?
Seismicity
ƒ WSDOT will meet American Association of State
Highway and Transportation Officials (AASHTO)
design standards with a design seismic event
equivalent to a 10-percent chance of exceedance in 50
years (425-year return period).
I-405, SR 169 to I-90, Renton to Bellevue Project Environmental Assessment | March 2006
Geology and Soils
5.13-4
ƒ WSDOT will implement design methods to make
project elements stable under the design AASHTO
event and limit susceptibility to collapse under an
unlikely larger event.
Liquefaction-prone Areas
ƒ WSDOT will identify areas where liquefaction prone
soils may be located.
ƒ WSDOT will evaluate the potential effects to structures
from liquefaction, if structures underlain by
liquefaction-prone soils are identified.
ƒ WSDOT will use appropriate measures to reduce long-
term liquefaction and lateral spreading risks if it is
determined that liquefaction risks are unacceptable.
ƒ WSDOT will develop the means and methods to avoid
or minimize settlement resulting from construction
vibrations associated with measures to reduce
liquefaction risks, if liquefaction prone soils are
identified.
Soft Ground Areas
ƒ WSDOT will take appropriate measures to assess and
reduce potential settlement problems associated with
existing utilities or structures in areas underlain by
soft, compressible soil.
ƒ WSDOT will design the structures and embankments
to accommodate or avoid the settlement if the potential
settlement is unacceptable.
ƒ WSDOT will develop the means and methods to avoid
or minimize settlement resulting from construction
vibrations in areas underlain by soft or loose soils.
Slope Stability and Landslide Areas
ƒ WSDOT will develop appropriate construction
procedures to maintain or enhance slope stability in
areas underlain by landslides or with landslide-prone
geology. The design through these areas will include
suitable wall types such as soldier piles with tiebacks,
possibly supplemented with enhanced drainage such
as improved surface drainage or horizontal drains.
I-405, SR 169 to I-90, Renton to Bellevue Project Environmental Assessment | March 2006
Geology and Soils
5.13-5
ƒ WSDOT will design earthwork and wall placement
sequencing plans, construction drainage plans, and a
slope monitoring program.
ƒ WSDOT will drain suspected or observed seepage to
reduce the risk of landslide and surface sloughing
through the use of gravel drainage blankets, french
drains, horizontal drains, placement of a surface rock
facing or other methods.
Dewatering
ƒ WSDOT will use properly designed, installed, and
operated dewatering systems.
ƒ WSDOT will control dewatering discharge to avoid
adverse effects.
Erosion
ƒ WSDOT will prepare and implement a TESC plan.
ƒ WSDOT will take additional action to minimize
erosion, maintain water quality, and achieve the
intended environmental performance, should any BMP
or other operation not function as intended.
Earthworks
ƒ WSDOT will place and maintain stockpiles properly to
avoid erosion or slope stability problems.
Permanent Drainage Systems for Cut Slopes
ƒ WSDOT will locate areas where permanent drainage
will be required by site conditions for cut slopes.
What measures are proposed to avoid or minimize
effects to geology and soils during operation?
Seismicity
ƒ WSDOT will implement its procedures for inspecting
critical highway elements following a major seismic
event.
Soft Ground
ƒ WSDOT will conduct long-term monitoring of
embankments or walls constructed on soft ground to
ensure that they are not experiencing unacceptable
settlement.
I-405, SR 169 to I-90, Renton to Bellevue Project Environmental Assessment | March 2006
Geology and Soils
5.13-6
Slope Stability and Landslides
ƒ WSDOT will conduct long-term maintenance of
surface and subsurface drainage in areas of landslide
risk. If installed, horizontal drains will be periodically
inspected and maintained, as these drains tend to clog
with time. If identified as a need during the design
geotechnical investigation, long-term monitoring of
slopes and walls may be appropriate in selected areas.