HomeMy WebLinkAbout65B-20.3(4) CONTINUED
BRUtSHED, EDC;ED AND FINISHED IN A WOIR)O�SHIP-4-IKE MANNER- CONCRETE SHALL BE PROMPTLY CLEANED FROM
THE E)0-OSED PORTI ON OF THE ANCHOR BOLTS AND CONDUIT WTER PLACEMENT. FOUNDATION SHALL ALL BE CLASS
-8- CONC1RETE. AFTER A CURING PERIOD OF TWO WFEVS, THE CONTRACTOR MAY INSTALL THE APPLICAELE DEVICE
THEREON.
TAEN F 1
TYPE OF DEVICE DIMENSIONS
Street Light Pole A- Deep x 31 Sq. or Dia.
Signal Pole 7- Deep x 3- Sq. or Dia.
Signal Controller See Detail Sheet
Street Light Control Cabi�t See Detail Sheet
Special Base See Detail Sheet
ALL CONCRETE FOUNDATIONS SHALL BE CONSTRUCTED IN THE MANNER SPECIFIED BELOW:
1) WERE SIDEWALK OR RAISED ISLANDS ARE To BE CONSTRUCTED AS A PART OF THIS PROJECT, THE TOP
OF THE FOUNDATION SHALL BE MADE FLL15H WITH THE TOP OF THE SIDL4ALK OR ISLAND. (SEE DETAIL
SHEET)
2) WHERE No SIDEWALKS ARE TO BE INSTALLED, THE GRA� FOR THE TOP OF THE FOUNDATION SHALL BE AS
SPECIFIED BY THE ENGINEER. (SEE DETAIL SHEET)
ALL CONCWTE FOUNDATIONS SHALL BE LOCATED AS PER STATIONING ON THE PLANS OR AS LOCATED BY THE
EW-INFER IN THE FIELD.
8-20.3(5) CONDUIT (REPLACEMENT SECTION)
TIJE CONTRACTOR SHALL PROVIDE AND INSTALL ALL U")LJIT AND NECESSARY FJTTINGS AT THE LOCATIONS NOTED
ON THE PLANS. CONDUIT SIZE SHALL BE 45 INDICATED ON THE WIRING AND CONDUIT SCHEDULE SHOWN ON
PLANS.
CONDUIT TO BE PROVIDED A1�10 INSTALLED SHALL BE OF THE TYPE INDICATED BELOW:
1) SCHEDULE 40 HEAVY WALL P.V.C. CONFORMING TO ASTM STANDARDS 9-011-L BE USED WHENEVER THE
11)t"IT IS TO BE PLACED OTHER THAN WITHIN THE ROADWAY AREA.
2) SDiEDULE 80 EXTRA HEAVY WALL P.V.C. CONFORMING TO ASTM STAN1DARDS SHALL BE I WHEN THE
CONDUIT IS TO BE PLACED WITHIN THE ROADWAY AREA.
ALL JOINTS SHALL BE MADE WITH STRICT COMPLIANCE TO THE. KAN.FACTURER'S RECOMMENDATIONS REGARDING
CEMENT USED AND ENVIRONMENTAL CONDITIONS.
8-20.3(6� JUNCTION BOXES (R �ACD4D41 SECTION)
THE CONTRACTOR SHALL PROVIDE A.ND INSTALL JUNCTION BOXES OF THE TYPE AND SIZE AT THE LOCATIONS
SPECIFIED IN THE PLANS AND AS PER DETAIL SHEETS.
T C INSCRIPTION ON THE COVERS OF ALL JUNCTION BOXES SHALL BE AS INDICATED BELOW:
1) STREET LIGHTING ONLY: "LIGHTING"
2) SIGNAL ONLY. "SIGNALS"
3) TRAFFIC SIGNAL ;VC STREET LIGHTING: -TS-LT"
4) TELEMETRY ONLY: "TELEMETRY"
INSCRIPTIONS ON JUWTION BOXES PE74FORMING THE SA14E FUNCTION, I.E. STREET LIGHTING, TRAFFIC SIGNAL,
OR BOTH, SHALL BE CONSISTENT THROUG1,0-rT THE PROJECT.
Supplemental Specifications
(Re� 05/01/86) Page 43